Window panel button decoration

Applicable models: Tesla Model S
Product Name: Glass Lifting Panel Sticker
Product material: ABS plastic
Product size: special car type
Product color: carbon fiber color
Product Quantity: 4 pieces in a set

Installation Notes:

Step 1: Simulate installation
Compare and adjust the position where the product is to be installed on the car to a suitable position, paying attention to the direction and the order of the product.
Step 2: Surface treatment
(1) Clean
Clean the parts that need to be installed with a non-fiber towel dipped in alcohol or clean water.
Precautions:
Before installation and bonding, the installation surface must be clean and dry, free of dust, fibers, water stains, oil stains or other contaminants. When the operating environment temperature is below 10 degrees, be sure to heat the bonding surface and the 3M adhesive layer on the product.
For the use of tackifier, a small amount of tackifier can be used on a cotton swab to make the paste more firm and stable.
(2) Installation
First tear off the protective film of the 3M adhesive layer on the back of the product, leaving the film on the outside, carefully adjust the position of the product to the correct position, then slowly tear off the film, and press the product in place.
(3) Let stand
Within 48 hours after the product is installed, the sticking part of the product should not be exposed to water, oil or dust, and should not be touched vigorously to prevent the glue layer from cracking.
【Precautions】

Please make sure that there is no moisture or oil on the car body before installation. Wipe it clean with a soft cloth, then paste and stick it firmly. Do not wash the car for two days after pasting. If the weather is cold or humid, please preheat the 3M tape for better effect.