מכשיר לעיסוי פנים EMS Artifact

Material: plastic

Color: rose red

Massager size: 10 cmx7.5cmx2.5cm

Cable length: about 110cm

Power: 2 x AAA battery (not included)

Massage mode: 4 (see picture below)

Instructions

1. Open the battery compartment, install the 2*AAA battery, and then close the battery compartment.

* Pay attention to the positive and negative parts of the battery.

2. Massage pad installation

a. Choose a suitable massage pad (small on the eye and bigger on the chin)

b. Please clean the treated part and keep it dry before use.

c. Connect the massage pad and wire

d. Plug the cable jack into the device port

e. Remove the protective film from the massage pad and stick it on the face.

f. Before starting the machine, please confirm whether the two patches are correct at the treatment site.

3. Press the power button (ON) to activate the device, then press (Menu) to select the operating mode.

4. Continue to work after selecting the suit mode

*The treatment period is 15 minutes. This means it will stop automatically after 15 minutes. If you want to stop within 15 minutes, press the button (OFF) until the intensity/speed is the weakest, press the button (S/P), then press the button (OFF) until the intensity/speed is the weakest. Finally press the Continue button twice (off) to stop working.

5. Strength level selection

Press the button (menu) and the default intensity value is the weakest. Press (On) / (Off) to increase/decrease the intensity level

6. Speed level selection

Press (On) / (Off) to increase/decrease the speed level

* After adjusting the speed, if you need to adjust the intensity level, press (S/P) once.

* After adjusting the intensity level, if you need to adjust the spedd level, press (S/P) once.

important hint:

Because other modes (2~4) have better stimulation effect, it is not suitable for eye position. So when you massage your eye position and eye area, please choose mode 1