לוח יחיד OBD2 Power Lifter

feature:

Increase horsepower by 35%
Up to 25% increase in torque
Enhanced throttle response
Increase 0-60 acceleration
Engagement and crisp transition
Eliminates engine and turbo lag
Fast 60 second installation
Keep your vehicle safe
Dyno tested and approved performance


Installation time 2-3 minutes:

Remove the key from the ignition switch.
Plug Nitro into the OBD2 port.
Insert the key and put it in ACC mode (click 1 on the right).
Press the reset button (the small hole above the nitro logo) for about 5 seconds, then release it. Just wait about 30-40 seconds. (Nitro Powerbox will communicate and establish a connection with the ECU). Nitro works based on the OBD2 protocol to remap the car’s computer ECU. After driving a total of 200 kilometers/150 miles, the Nitro power chip will adjust itself according to the driver's habits and always remap the ECU to improve the engine's performance.

Start the engine.